Monday, February 28, 2011
Pre-weld mockup with engine
Did a new set up with the frame, engine and front and rear wheels. I did some modification to the hardtail frame. It was not fitting very well so I cut the cross support and seperated the frame into two pieces. I was able to line up one side of the frame with the original swingarm in place and clamp it right where it needed to be. Then I removed the swingarm and installed the other side of the hardtail and clamped that into place, then installed the tire.
By cutting the cross supports I was also able to widen the tail and fit the original Honda wheel in much better.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment